Alternate picking means playing down, up, down, up in a strict sequence, even when notes cross strings. To build speed evenly, start slow enough that every downstroke and upstroke sounds the same in volume and timing, then raise the tempo in small steps. Evenness comes first, and speed follows.
What alternate picking is
Downstrokes usually fall on the beat and upstrokes on the off-beats. Strict alternate picking keeps this down-up pattern going whether you are playing on one string or moving across strings. Some players use economy picking, which skips strict alternation on some note groups. Both approaches have their place, but this article focuses on strict alternation.
Build evenness first
Start with a single string and steady eighth or sixteenth notes at a slow tempo. Listen to your downstrokes and upstrokes. They should have the same volume, attack, and tone. If upstrokes sound weaker or catch on the strings, check your pick angle and how much pick is exposed.
Keep the fretting hand in sync
Many speed problems are timing problems between your two hands rather than problems with the pick. The fretting hand often falls behind before the picking hand does. Play slowly enough that each fretting finger lands with its pick stroke. Notes that come out late often mean the fretting hand is behind.
Tempo steps with a metronome
Pick a tempo where every note is clean, then raise it by 2 to 5 BPM after several clean repetitions. When tension shows up, such as a tight forearm or muddy notes, drop back to the last clean tempo. Keep a log of tempos for each exercise. Over several weeks, the log shows real progress more clearly than memory does.
Tempo math
Knowing how many notes per second you need makes it easier to set goals. For 16th notes, notes per second equals the BPM divided by 15. At 120 BPM that is 8 notes per second, at 160 BPM it is about 10.7, and at 200 BPM it is about 13.3. For eighth notes at 120 BPM, you play 4 notes per second.
Many guitarists treat 16th notes at 160 to 180 BPM as fast and 200 BPM and up as very fast. These benchmarks vary, so use them only as a rough reference.
String changes: inside and outside picking
String changes are where alternate picking gets tricky. Inside picking moves the pick between two strings. Outside picking moves it around them. Pickslanting describes which direction the pick is angled. With downward pickslanting, upstrokes escape the strings, so changes after an upstroke are easy. Upward pickslanting is the reverse. These terms were popularized by Troy Grady’s work on picking technique.
The stroke that ends each string also matters. With three notes per string, as in 3-notes-per-string major scale patterns, the stroke that ends each string alternates, so the pick must handle both kinds of change. With four notes per string, the same stroke ends every string, which makes the pattern more predictable.
Burst practice
Play short fast groups at or above your target tempo, then rest. Bursts complement slow practice and help you feel what fast playing requires. Keep each burst short so tension does not build up.
Watch for tension
Stop if your forearm or wrist starts to ache. Pushing speed drills too hard can strain tendons, so rest between sessions and keep sessions reasonable. Keep the pick motion small and the grip relaxed. Tension is one of the most common limits on speed.
Common mistakes
- Playing fast before the rhythm is even.
- Assuming slow practice transfers to speed on its own. Fast motion often needs its own practice, so use bursts as well as slow work.
- Believing your motion must look the same at every tempo. Your motion will change as the tempo rises.
- Ignoring the fretting hand. Timing problems often start there.
Where to go next
For accuracy drills, see how to get more accurate at picking guitar. For the picking basics, read guitar picking technique. For the 16th-note grid that many fast passages use, see 16th note strumming. The tremolo picking in metalcore guitar techniques relies on the same strict alternation.