Choosing a Guitar

Are archtop guitars harder to play?

Archtop guitars are not inherently harder to play. Heavy strings, high action and body size usually cause the difficulty, and a good setup often helps.

On this page
  1. Are archtop guitars harder to play?
  2. Why archtops can feel hard
  3. String gauge matters most
  4. Action and the floating bridge
  5. Scale length and tension
  6. Body size and reach
  7. Neck profile and weight
  8. A setup checklist
  9. Common misconceptions
  10. Conclusion

Are archtop guitars harder to play?

Archtop guitars are not inherently harder to play. Heavy strings, high action and body size usually cause the difficulty, and a good setup often helps. Many archtops feel close to a solid-body guitar once they are set up with lighter strings and the action is lowered.

Why archtops can feel hard

Archtops can feel hard for a few common reasons:

  • Heavy strings. Jazz archtops often ship with flatwound strings and a wound G string, which feel stiffer than typical 9s or 10s.
  • High action. A floating bridge set too high makes the strings harder to press.
  • Large body. Full-hollow bodies, often 16 to 18 inches across and 3 to 3.5 inches deep, can feel bulky, especially when you stand.
  • Chunky necks. Vintage-style necks are often chunky. Modern necks tend to be slimmer.

Each of these is usually a setup or choice issue, not a flaw in the arched top itself.

String gauge matters most

Strings have the biggest effect on how an archtop feels.

  • Jazz flatwounds. Common sets are 12–52 or 13–56. Flatwounds feel stiff under the fingers, and jazz players often prefer them for their tone.
  • Roundwounds. A set of 10–46 or 11–49 roundwounds makes most electric archtops feel like a solid body.
  • Acoustic archtops. These need heavier strings, often 12s or 13s, to drive the top. Lighter sets can sound thin.

Lighter strings are not a free fix on acoustic archtops. Volume and tone can drop, so change the gauge only after you have heard the difference.

Action and the floating bridge

Many archtops have a floating bridge held in place by string tension. You can raise or lower it with the thumbwheels, which is quick and needs no tools.

Two things to keep in mind:

  • Mark the position before you change strings. The bridge can shift, and the intonation can go off.
  • High action is not always a neck problem. Often the bridge just needs lowering.

Changing the string gauge may also require recutting the nut slots or adjusting the bridge.

Scale length and tension

Many Gibson-style archtops use a scale length of about 24.75 inches. That is slightly shorter than a 25.5-inch Fender scale. At the same gauge, a shorter scale has slightly less tension, which can make the strings feel a little softer under the fingers.

Body size and reach

Full-hollow archtops usually join the neck at the 14th fret. Semi-hollow models such as the ES-335 usually join at the 19th fret, which gives easier access to the upper frets. Many archtops are single-cutaway, which also improves access. Non-cutaway models limit access to the high frets.

Semi-hollow archtops are around 1.75 inches deep and feel much like a solid body. Full-hollow archtops, at about 3 to 3.5 inches deep, feel very different.

Neck profile and weight

Neck profiles vary. Vintage-style models often have chunkier necks, and modern ones are often slimmer.

Weight also varies widely. Many laminated electric archtops weigh about the same as, or less than, a Les Paul-style guitar. If weight matters to you, check it in person.

A setup checklist

  • Try lighter strings. On an electric archtop, try a 10s or 11s roundwound set before you decide it is too hard.
  • Check the action at the 12th fret. If it is high, lower the floating bridge.
  • Check the intonation. Compare the 12th-fret harmonic with the fretted 12th-fret note.
  • Consider a single cutaway. It helps if you play a lot of upper-fret parts.
  • Try a semi-hollow. If a full-hollow feels bulky, a semi-hollow body is often more comfortable.

Common misconceptions

  • “Archtops are inherently hard to play.” Most of the difficulty comes from heavy flatwounds and high action.
  • “Lighter strings are a free fix on acoustic archtops.” They can cost you volume and tone.
  • “Semi-hollow and full-hollow archtops feel the same.” They differ a lot in comfort.

Conclusion

Archtops are not inherently harder to play. Start with the strings and the action, then check the bridge and the body size. If the guitar still feels hard, try a semi-hollow body. To learn more about the types, see what an archtop electric guitar is. For uses by style, see what archtop guitars are good for.

The complete guide to choosing a guitar

How to Choose the Right Guitar Size
Read the guide

Keep exploring

Guides from other topics

All topics →