Intonation is how accurately your guitar stays in tune as you move up the neck. A well-intonated guitar sounds right on the open strings, at the 12th fret, and everywhere in between. You can check it with a tuner by comparing the 12th-fret harmonic with the fretted 12th-fret note, then moving the saddle until the two match.
When intonation is off
- Chords sound out of tune as you move up the neck.
- Open strings are in tune, but the same strings sound off when fretted.
- A note sounds sharp even after you’ve tuned the open string.
Before you start
- Use fresh strings. Old strings won’t intonate correctly. See how to change guitar strings.
- Set neck relief and action first. Intonation comes after them and before pickup height. See how to adjust action on an electric guitar.
- Use an accurate tuner. A strobe tuner, or one accurate to about 1 cent, is ideal. Aim to land within about 1 to 2 cents.
- Have the right tool. You need a small screwdriver or hex key that fits your bridge’s saddle screws.
Step by step on an electric guitar
- Tune the open string to pitch.
- Play the 12th-fret harmonic. Lightly touch the string over the 12th fret and pluck. The harmonic sounds an octave above the open string. Note the tuner reading.
- Play the fretted 12th-fret note. Press the string at the 12th fret in playing position, and pluck. Pressing too hard pulls the note sharp, so fret firmly but lightly. Compare this reading with the harmonic. Both should sound an octave above the open string, so they should match each other.
- Move the saddle if the two don’t match.
- If the fretted note is sharp, move the saddle back, away from the neck, to lengthen the string.
- If the fretted note is flat, move the saddle forward, toward the neck, to shorten the string.
- Make small changes. Slacken the string slightly before you move the saddle, so it doesn’t bind or scratch. A small turn can make a big difference, so move the screw a little at a time.
- Retune the open string, then recheck. Compare the harmonic and the fretted 12th again. Repeat until they match within about 1 to 2 cents.
- Repeat for each string. Then play chords and scales up the neck and listen.
Some players also check the 7th and 15th frets for an extra comparison. That can help you catch a small error the 12th fret doesn’t show.
Saddle position and bridge types
Each string’s saddle is set separately. Wound strings usually sit further back than the plain strings, and the low E is often furthest back. A plain G often sits behind the B.
How you move the saddles depends on the bridge:
- Strat-style bridges usually have an adjustment screw at the back of the bridge plate for each saddle.
- Tune-o-matic style bridges vary, so test the screw first. Make a small change, then check which way the saddle moves.
- Floyd Rose-style tremolos need more steps: detune, loosen the saddle lock bolt, move the saddle, lock it, and retune. Many players use an intonation tool, or leave this job to a tech.
Scale length is the distance from the nut to the saddle. Fender-style guitars are about 25.5 inches, and Gibson-style guitars are about 24.75 inches. Saddles often sit slightly past that nominal length, which is normal.
Acoustic guitars
Acoustic guitars usually have fixed saddles. You can’t move them at home the way you can on an electric. An intonation problem on an acoustic usually needs a compensated saddle or work by a luthier. The tuner check still helps you see the problem and decide what to do.
Common misconceptions
- A fretted guitar can be perfectly in tune everywhere. No fretted guitar is perfect across the whole neck. Equal temperament is a compromise.
- Intonation is permanent. Redo it after you change the gauge, the tuning or the action.
- A tiny saddle move is a small change. It can be a big change, so use small turns.
- The truss rod fixes intonation. It doesn’t. Intonation is set at the saddles.
Safety: Keep your fingers clear of the saddle edges and the string ends when you adjust a string under tension.