Two alternate tunings come up often. Half step down lowers every string by one semitone, and the shapes you already know still work, just a half step lower. Open D turns the open strings into a D major chord. A half step (semitone) is one fret, and a whole step (tone) is two frets. Both tunings move the strings by those distances.
| String | Standard | Half step down | Open D |
|---|---|---|---|
| 6th (lowest) | E | Eb | D |
| 5th | A | Ab | A |
| 4th | D | Db | D |
| 3rd | G | Gb | F# |
| 2nd | B | Bb | A |
| 1st (highest) | E | Eb | D |
Half step down (Eb standard)
Half step down, also called Eb standard, tunes every string one semitone lower than standard. From low to high, the notes are Eb, Ab, Db, Gb, Bb and Eb.
What changes:
- The shapes stay the same, but everything sounds a half step lower. A G chord shape sounds as Gb (F#) major.
- String tension drops. One semitone lower cuts tension by roughly 11 percent. That makes bending easier and the strings feel looser.
- The tone is slightly darker, and a lower key can suit a singer more easily.
Who plays half step down
Jimi Hendrix, Stevie Ray Vaughan, early Van Halen and Guns N’ Roses on Appetite for Destruction are often cited as half-step-down players. Kurt Cobain’s Nirvana recordings are also often tabbed this way. Check the recording if you want to be sure of a particular song.
How to set it up
- Set your tuner to A = 440 Hz. Then tune each string to its new note name: Eb, Ab, Db, Gb, Bb and Eb.
- Loosen each string gradually. Finish each one by tuning up to the note, so the string is held firmly at the tuner.
- Make two or more passes. Tension changes on one string shift the others.
- To play along with standard-tuned songs, put a capo on the 1st fret. The capo raises Eb standard back to standard pitch.
Some players go up one gauge, from 10s to 10.5s or 11s, to get back the feel they had in standard tuning. Lighter sets can feel floppy and may buzz in a lower tuning. If you have a floating tremolo, changing the tuning or gauge can tilt the bridge, so you may need to rebalance it.
Open D tuning
Open D tunes the strings to D, A, D, F#, A and D, from low to high. Strummed open, the strings sound a D major chord.
To get from standard to open D:
- Low E down a whole step to D
- A stays the same
- D stays the same
- G down a half step to F#
- B down a whole step to A
- High E down a whole step to D
Barring the whole neck also gives a major chord. At the 5th fret you get G major, at the 7th you get A major, and at the 12th you get D major.
Open D is popular in blues, slide playing and folk fingerpicking. If fingerpicking is new, start with fingerstyle guitar for beginners. Song tunings vary between tab sites, so check the recording before you assume a song is in open D.
To set up open D, use the same steps as above: tune each string to its new note, approach the note from below, and make two or more passes.
Common misconceptions
- Half step down is the same as drop D. It isn’t. Drop D lowers only the low E, to D. Half step down lowers all six strings. Drop tunings for heavier styles are covered in metalcore guitar techniques.
- Open D is the same as DADGAD. It isn’t. DADGAD is a suspended tuning.
- Eb tuning means songs are in the key of Eb. It doesn’t. It only changes the pitch of the strings. To play in the key of Eb from standard tuning, see how to capo for Eb.
- Tuning down doesn’t affect the guitar. It does. Tension changes, so the relief and intonation may need a check. See adjusting action on an electric guitar and how to intonate a guitar.
Safety: When you tune up to pitch, approach it gradually. Cranking a string well past pitch can snap it at the tuner or the saddle.