Changing strings takes a little patience, mostly while the new strings stretch. The steps are the same for most guitars: remove the old strings, clean the fretboard, thread the new strings through the bridge, wind them onto the posts, then stretch and tune. Acoustic and electric guitars differ mainly at the bridge.
When to change strings
Change strings every 1 to 3 months if you play regularly. Change them sooner if they look dull, sound dead, or won’t hold tune or intonation.
What you need
- A string winder. Many acoustic winders have a notch for pulling bridge pins.
- Wire cutters
- A tuner
- A soft cloth
- A neck rest, optional, to support the guitar
- Eye protection, since snapped strings can whip
Remove the old strings
Slacken each string fully before you cut it or pull it out.
You can change all the strings at once if you want to clean the fretboard in one go. On a floating bridge, such as a floating tremolo or an archtop, change one string at a time so the bridge stays put.
On an acoustic, pull the bridge pins with the notch in the winder, then lift out the old strings.
With the strings off, clean the fretboard. Rosewood and ebony boards benefit from a light conditioner or a lemon-oil-based product once or twice a year. Finished maple boards don’t need oil, so just wipe them.
Acoustic: string the bridge
- Push the ball end of the new string into its hole in the bridge.
- Push the bridge pin back in with its groove facing the string. While you push, pull up gently on the string so the ball end seats against the bridge plate.
- Tug the string gently to check that it’s locked.
Electric: string the bridge
Thread each string through the bridge, the tailpiece, or the through-body ferrule, depending on your guitar’s design.
Wind the strings onto the posts
- Pull the string taut toward the tuning post, then leave about 2 to 3 inches of slack past the post.
- Feed the string through the hole in the post. Kink the string at the hole so it won’t slip.
- Wind downward. Winding downward increases the break angle of the string over the nut.
- Use 2 to 3 wraps on wound strings and 3 to 5 wraps on plain strings. Locking tuners need little or no wrap.
- Tune up to the note.
More wraps aren’t better. Too many can slip and hurt tuning stability.
Trim, stretch and retune
- After tuning, trim the excess about 1/4 inch (6 mm) past the post.
- Stretch each new string: pull it gently away from the fretboard along its length, retune, and repeat two or three times.
- Steel strings settle in a day or two. Expect to retune often for the first few days.
Classical guitars
Classical guitars use tie-end strings at the bridge, not ball ends. Nylon strings keep stretching for several days, so expect frequent retuning. For the differences between string types, see guitar string types.
Common mistakes
- Too many wraps. Extra wraps can slip and hurt tuning stability.
- Too few wraps, or no kink at the post. The string can slip.
- Expecting new strings to stay in tune right away. Stretching is part of the job.
- Putting steel strings on a classical guitar. Never do this. The much higher tension can damage the bridge and neck. Steel string vs nylon string guitars explains the difference.
Safety: Wear eye protection. Snapped strings can whip, and the cut ends are sharp, so trim them close to the post.