A classic jazz guitar tone is warm, round, and clean. The attack is soft, the low end is full without being boomy, and the top end is smooth rather than bright. You can get there with a fairly simple setup. Most of the work happens on the guitar’s controls and in the way you pick.
The numbers below are starting points. Guitars, pickups, amps, and rooms vary a lot, so use them as a place to begin and adjust by ear.
What a classic jazz setup looks like
The traditional setup is an archtop or other hollow-body guitar with a neck humbucker, played through a clean amp. Gibson ES-175 and L-5 guitars are well-known examples. Wes Montgomery played with his thumb on a Gibson L-5, and Joe Pass played an ES-175.
You don’t need a hollow body to get a jazz sound. Semi-hollow guitars are widely used, and Ed Bickert was known for a classic jazz tone on a Telecaster. Solid bodies can work well too.
Guitar settings
- Neck pickup. The neck position gives the rounder, warmer voice many jazz players want.
- Tone knob. Roll it down to about 3 to 6. The right point depends on the guitar, the pickup, and the room. A tone knob at 0 is often too muddy in a band or on a recording.
- Volume knob. Many players keep it around 7 to 9 to soften the attack. The amp makes up the difference.
- Picking position. Pick about halfway between the neck and the end of the fretboard, or over the board, for a warmer attack.
- Right hand. Try the thumb, as Wes Montgomery did, or a pick. Both are used in jazz.
Amp settings
Start with the gain as low as it goes, then set the EQ:
- Gain or drive: minimal
- Bass: about 5 to 7
- Mid: about 5 to 6
- Treble: about 3 to 5
- Bright switch: off
Clean amps often linked with jazz include the Fender Twin Reverb, the Roland JC-120, and the Polytone Mini-Brute. Any clean amp with a full low end can work, so start with the settings above and adjust from there.
Strings and picks
Flatwound strings give the traditional thump and less finger squeak. A set in the .012 or .013 range with a wound G is a common choice. Heavier flatwounds raise string tension, so check the truss rod and action after the change. Adjusting a truss rod with the strings on covers the first step.
Many modern players use roundwounds, so flatwounds aren’t a requirement.
For picks, a thick one, around 1.0 to 1.5 mm or more, is a common choice for jazz. Guitar picking technique covers how pick thickness changes the feel. The Dunlop Jazz III, at 1.38 mm, is a popular example.
Reverb and effects
For a traditional jazz sound, keep reverb light, around 10 to 20%, or switch it off. A small room or spring setting works well. How much reverb to use covers placement and levels.
Fusion and modern jazz players often use more effects, including chorus, delay, light overdrive, and extra treble. A light overdrive can add some grit for a solo without changing the basic character. Overdrive vs distortion pedals explains the difference.
Feedback at higher volume
Hollow bodies feed back when the volume is high. To reduce it, turn the volume down, move farther from the amp, or fit a soundhole plug such as a Feedback Buster.
Common misconceptions
- You need a hollow-body archtop. Semi-hollows, Telecasters, and other solid bodies are widely used.
- The tone knob should stay at 0. That’s often too muddy in a band or on a recording.
- Flatwounds are mandatory. Many modern players use roundwounds.
- Jazz means no effects. Fusion and modern jazz use reverb, delay, chorus, and sometimes overdrive.
Use these settings as a starting point. The numbers only matter once your ears confirm them. For a method you can apply to any amp, see how to set your guitar tone.